CRL DCD and HBT Series Electro-Formed Diamond Drills have a thin wall with a 1/2″ (12.7 mm) deep multi-layer of diamonds and bonding matrix. These drills are designed for high speed, high production drilling, and produce outstanding results when exacting conditions are met.
Due to the fragile nature of these types of drills, they should be used in a precision machine, never allowing too much pressure to be applied. It is important to handle these types of diamond drills with care and use on flat surfaces only. Sharpening or “dressing” of these drills before each use will substantially increase their cutting capabilities. A dressing stone is a recommended necessity when working with an Electro-Formed Diamond Drill.
IMPORTANT NOTE:CRL DCD and HBT Series Diamond Drills have a very thin wall which makes them EXTREMELY FRAGILE. They are intended for the drilling of flat (plate) glass ONLY, in a true running, production type drilling press.
NEVER perform any type of freehand drilling. The use of a hand drill requieres a stabilization base such as a our GDB1 & GDB2 Glass Drilling Bases. Extreme care and caution should be used as the use of these drill in any other manner other than as specified may damage the bit and void warranty.
Always wear the proper safety gear including gloves and eye protection when drilling glass. Work should be performed on a flat, horizontal surface. A Ground Fault Circuit Interrupter must be used when using any type of electric tool in conjunction with water or coolant. Failure to follow any of these precautions can result in operator injury.
Most shipping weights are approximate and have not been verified. If the exact weight is needed in order to determine shipping costs, and shipping costs are required in order for you to complete your order, please request this prior to submitting your order by contacting CRL Customer Service. Product images shown are of the actual product or a close representation. Colors can vary depending on your computer’s video card and on how your monitor’s color is adjusted.
Diameter
2″
Overall Length
3 in (76 mm)
Recommended Speed
1200 RPM
Drill Diameter
2″ (50.8 mm)
RPM Range
1200
Style
DCD Series
Shank Diameter
3/8
For Use On
Flat (Plate) Glass ONLY
Shank Type
Reduced Round
Shaft Size (Inches)
3/8 x 1-3/8
Shaft Size
3/8 in. X 1-3/8 in. (10 mm X 35 mm)
